Pro/Engineer 2000 Book

Section 1: Introduction Section 2: Using the Text Section 3: Fundamentals Section 4: Modes and File Management Section 5: Interface Section 6: Utilities Section 7: Setup, Information, and Analysis Section 8: Layers Section 9: The Sketcher Section 10: Help Section 11: Model Tree Section 12: Intent Manager PART I: CREATING PARTS Lesson 1: Protrusions and Cuts (Clamp) / Project: Angle Block Lesson 2: Modify and Redefine (Base Angle) / Project: T-Block Lesson 3: Holes and Rounds (Breaker) / Project: Guide Bracket Lesson 4: Datums and Layers (Anchor) / Project: Angle Frame Lesson 5: Revolved Protrusions and Neck Cuts (Pin) / Project: Clamp Foot and Clamp Swivel Lesson 6: Chamfers and Cosmetic Threads (Cylinder Rod) / Project: Clamp Ball and Coupling Shaft Lesson 7: Pattern and Group (Post Reel) / Project: Taper Coupling Lesson 8: Ribs, Relations, and Failures (Adjustable Guide) / Project: Clamp Arm Lesson 9: Drafts, Suppress, and Text Protrusions (Enclosure) / Project: Cellular Phone Bottom Lesson 10: Shells, Reorder, and Insert Mode (Oil Sink) / Project: Cellular Phone Top Lesson 11: Sweeps (Bracket) / Project: Cover Plate Lesson 12: Blends and Splines (Cap) / Project: Bathroom Faucet Lesson 13: Helical Sweeps and 3D Notes (Helical Compression Spring) / Project: Convex Compression Spring PART II: ASSEMBLIES Lesson 14: Assembly Constraints (Swing Clamp Assembly) / Project: Coupling Assembly Lesson 15: Exploded Assemblies (Exploded Swing Clamp Assembly) / Project: Exploded Coupling Assembly PART III: GENERATING DRAWINGS Lesson 16: Formats, Title Blocks, and Views (Clamp Arm Drawing) / Project: Base Angle Drawing Lesson 17: Detailing (Breaker Drawing) / Project: Cylinder Rod Drawing Lesson 18: Sections and Auxiliary Views (Anchor Drawing) / Project: Cover Plate Drawing Lesson 19: Assembly Drawings and BOM (Swing Clamp Assembly Drawing) / Project: Coupling Assembly Drawing Lesson 20: Exploded Assembly Drawings (Exploded Swing Clamp Drawing) / Project: Exploded Coupling Assembly Drawing PART IV: ADVANCED CAPABILITIES Lesson 21: User-Defined Features and Family Tables (Coupling Fitting) / Project: Tool Body Lesson 22: Pro/NC (Adjustable Guide Machining) / Project: Clamp Arm Machining / APPENDIXES / A. Advanced Projects / B. Config.pro Files and Mapkeys / C. Glossary / D. Design Intent Planning Sheets / INDEX